Wednesday, January 5, 2022

Assembling the test pack

I started assembling the batteries today this is just the first few rows.


I 3d printed a cell holder which I use to hold the high temp rtv till it dries.

Here is the bms and wiring harness.

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Slow going

This project has been a slow burner.  Mostly because I'm eating in the FAA to get my registration transferred.  But I'm ...

  • Motor Update
    I received the motor it's a FreeRCHobby 240105 The Rotax 447 was pulled An empty engine compartment The electric motor is trial fit The ...
  • It spins
     I wired the throttle, display, and enable to the test controller.  After about an hour of setting parameters in the "bacdoor" app...
  • First battery build... lessons learned
    Here are some things I'd do differently on the next pack The pack needs structure, the wrap is good, but not enough to reall...